sâmbătă, 14 decembrie 2013

Wi-Fi Protected Access For All

Discussing about the Wi-Fi Support we define Wi-Fi Protected Access as the certification program. To point out the compliance with the security protocol this Wi-Fi Support are greatly used.

FEATURES OF THE WI-FI SUPPORT SECURITY ACCESS:

In the Wi-Fi Protected Access of Windows XP Support, following are its security features:

Authentication of Wi-Fi Protected Access: This Wi-Fi Support, Wi-Fi Protected Access, requires an authentication of 802.1x even when it is providing Windows XP Support. WPA maintains the utilization of a pre shared key for environments that is present without Remote Authentication Dial-In User Service (RADIUS) infrastructure. But if the environment consists of RADIUS infrastructure then Extensible Authentication Protocol (EAP) and RADIUS are both supported.

Key Management for Wi-Fi Protected Access:

Re entering the unicast encryption keys gets optional for 802.1 x. No mechanisms are there for 802.11 and 802.1x to make a change in the global encryption key. The global encryption keys find its use for the broadcast traffic and multicast traffic. Re entering of both the encryptions, such as global encryption and unicast encryption, with WPA is required.

The Temporal Key Integrity Protocol (TKIP):

The WEP or Wired Equivalent Privacy is not restricted for 802.11. The WPA Wi-Fi Support requires encryption that uses TKIP. With a fresh encryption algorithm, the WEP gets replaced by Temporal Key Integrity Protocol. This Protocol in Windows XP Support offers much strength than the WEP.

There are certain other facilities obtained from a Temporal Key Integrity Protocol. Such as:

The security configuration verification are determined just after the encryption keys For the authentication of preshared keys, the unique starting unicast encryptions are determined. For every frames a synchronized alteration of the unicast encryption keys are prepared.

Michael:

A 32-bit Integrity Check Value (ICV) is provided to the data integrity along with 802.11 and WEP Wi-Fi Supports. The ICV is affixed with 802.11 payloads and it is encrypted with WEP.

AES Support:

The use of Advanced Encryption Standard (A ES), as WEP defines, is a bonus substitute for the encryption of WEP. Support of AES can be optional as the user may be unable to add this Wi-Fi Support to existing wireless equipment through a firmware.

An Assorted Blend of WEP and WPA wireless clients are supported:

A wireless AP can lend their hands to WPA and WEP clients for providing support to the steady evolution of WEP-based wireless networks to WPA.

CHANGES REQUIRED TO SUPPORT WPA:

Following are the software changes required for WPA:

The network Adapters should be wireless The client programs should be wireless Access points which should be wireless

Changes to the Wireless Network Adapters:

To provide full support to the WPA, the wireless network adapters has to be upgraded. From the vendor who has provided you wireless network adapter obtain a WPA update.

Changes to Wireless Client Program:

To provide permission towards the configuration of the new WPA encryption algorithms and WPA authentication the wireless client program must be updated.

Changes to Access points which should be wireless:
To provide support to the following, updation of the wireless access points must be implemented:

For Windows XP Support the WPA must offer a two-phase authentication AES TKIP Element for the new WPA informations

Wireless clients using Windows XP Support or Windows 2000 as your system operating system must install and obtain a new WPA-compliant configuration tool.



access point vs router

Niciun comentariu:

Trimiteți un comentariu