How To Connect PS3 on the Internet

1. Connection "By Wire" for users who use dialers to connect to the Internet.

1.1 - Ip 1.2 - Subnet Mask 1.3 - Standard Router 1.4 - Primary DNS 1.5 - Secondary DNS

2. Connection "Wireless" for those with Kyocera's trademark "Buffalo" WI-FI AirStation with the option "AOSS". This configuration using a router "Buffalo - WHR-G54S / U". ____________________________________________________

Starting the configuration of connection "By Wire".

1 - Go to "Settings", then "Network Settings".

1.2 - Internet Connection Settings

1.3 - Method of connection "Connection by wire"

1.4 - Custom

1.5 - Automatic detection

1.6 - Manual

1.7 - Here we make the configuration of PC - Subnet Mask - Router Standard - Primary DNS and Secondary DNS.

To put the IP if you do not know, just click: Start - Run and type CMD and the command will display the screen of the DOS Prompt, type ipconfig it, will soon show: IP Address Subnet Mask Default Gateway, the same as Default Router that is written in the PS3. The first is that IP is the IP informing that the PC is using, when it was configured, so let's just change the last number: Ex: PC's IP 192.168.11.10 change only the last number in the PS3 thus putting 192.168.11.11 Subnet Mask will use the same standard as it is showing you 255.255.255.0 Default Gateway is the IP from your "router", "modem" that will put you in the Default Router PS3.

To configure DNS primary and secondary DNS, just call and ask for phone numbers, for those who are in your country. Example of how the configuration will be to continue the setup

IP 192.168.11.11 Subnet Mask 255.255.255.0 Default router - the IP router Primary DNS -- Secondary DNS --

1.8 - MTU "Automatic"

1.9 - Proxy Server "No Use"

1.10 - UPnP "Enable"

1.11 - Confirm the installation and test the connection

__________________________________________________________________________

Starting the configuration of connection "Wireless"

2. Follow steps 1 and above 1.2

2.1 - Method of connection "wireless"

2.2 - WLAN Settings "Automatic"

2.3 - Select the option "AOSS"

2.4 - Just push the button at the top of the router as it is in the picture and wait for the PS3 could receive the settings that are fully automatic.

/img160/7892 ... 54seg0.jpg

2.5 - There is no need to use the advanced settings just put on "No" and move

2.5 Just save the setting and then test so you can verify the certification.

access point vs router