DD-WRT Wireless Router Bridge Linksys wrt65gs and 160n

In this how you can information I can be showing you ways create a wireless bridge between a Linksys 160n wi-fi router and a Linksys WRT54GS wi-fi router that has been modded with the DD-WRT firmware. You would possibly ask yourself what is a wireless bridge.You additionally could ask your self why you'd need to create a wireless bridge within the first place. Properly a wi-fi bridge is when you connect one router to another router without utilizing any arduous wired cables. Chances are you'll need to create a wi-fi bridge for among the following reasons.

Laptop are located at different ends of your house and you can't run a ethernet cable between the two router. You wish to hyperlink to you neighbors community so you'll be able to share internet service, files, and media corresponding to music and movies. The probabilities are infinite in relation to networking routers together using wireless.

For the wireless bridge setup I shall be utilizing the ne xt ip deal with and subnet setup:

* Wi-fi Router 1 = Linksys WRT160n 192.168.1.0/24
* Wireless Router 2 = Linksys WRT54GS-WRT mod 10.0.1.0/24

The Linksys WRT 160n wireless router might be immediately related to the Web service, and the Linksys WRT54GS DD-WRT modded router will create the wi-fi link between the 2 routers. One of the best ways to setup your wireless bridge is to have a computer that has both a wifi connection and a ethernet connection. To start out the installation, use your wi-fi connection to connect with router 1, which is the Linksys WRT160N. After you have got connected the router, open your internet browser and sort within the default gateway which should be 192.168.1.1. Click on the Standing Tab and be sure that router 1 has a web connection.
After you recognize that the first router has a web connection, go to the Wireless Safety Tab and setup the encryption sort and paraphrase key. Make sure that you are utilizing suitable encryption between each of the routers.linksys-wrt160n-wpa-wireless-safety

After you have got set the encryption kind and key on the primary router, disconnect from this router. Now hook up with the WRT54GS DD-WRT modded router, then go to the setup tab and change the native community to 10.0.1.0 or no matter community vary you prefer.

* Local Ip Address: 10.0.1.1
* Subnet Mask: 255.255.255.0
* Gateway: 10.0.1.1
* Local Dns: 10.0.1.1

After you might have modified the community setup in your modded DD-WRT router, disconnect from the router then reconnect to so that you simply receive your new ip address. Your new ip address should be someplace within the 10.0.1.0 network. Now open an online browser at point it towards 10.0.1.1, which is now the default gateway to your WRT54GS DD-WRT modded router.

Now go to the status tab and click on the wireless tab. Inside the wi-fi tab you should see a button that says web site survey. The location survey button is located in the direction of the bottom of the page. All it's important to do now could be choose router 1 from the listing, which should be the Linksys WRT160N.

After you have chosen router 1 from the list, go to the wireless tab and click on the wireless safety tab. All you must do now's input the very same encryption kind and key that you simply setup for router 1. After you have got set the encryption kind and key into ybur modded DD-WRT router, all you need to do is apply the settings. You need to now have a wireless link between the Linksys WRT160N and the Linksys WRT54GS. Now join utilizing a wi-fi connection to the DD-WRT modded router, and make sure your internet connection work.

access point vs router