Dd-wrt Wireless Router Bridge Linksys 160n And Wrt54gs

On this the best way to guide I will be displaying you ways create a wi-fi bridge between a Linksys 160n wireless router and a Linksys WRT54GS wireless router that has been modded with the DD-WRT firmware. You would possibly ask your self what is a wireless bridge.You additionally could ask your self why you would wish to create a wi-fi bridge in the first place. Properly a wireless bridge is whenever you connect one router to a different router with out utilizing any onerous wired cables. Chances are you'll wish to create a wi-fi bridge for some of the following reasons.

Computer are located at totally different ends of your house and you cannot run a ethernet cable between the 2 router. You need to link to you neighbors community so you may share internet service, recordsdata, and media akin to music and movies. The chances are endless in relation to networking routers collectively utilizing wireless.

For the wi-fi bridge setup I shall be using the next ip handle and subnet setup:

* Wi-fi Router 1 = Linksys WRT160n 192.168.1.0/24
* Wireless Router 2 = Linksys WRT54GS-WRT mod 10.0.1.0/24

The Linksys WRT 160n wi-fi router will probably be immediately linked to the Internet service, and the Linksys WRT54GS DD-WRT modded router will create the wi-fi link between the two routers. The easiest way to setup your wi-fi bridge is to have a pc that has both a wifi connection and a ethernet connection. To begin the set up, use your wireless connection to hook up with router 1, which is the Linksys WRT160N. After you will have related the router, open your net browser and type within the default gateway which must be 192.168.1.1. Click on the Standing Tab and be sure that router 1 has a web connection.

After you already know that the first router has a web connection, go to the Wi-fi Security Tab and setup the encryption sort and paraphrase key. Make sure that you are utilizing suitable encryption between both of the routers.linksys-wrt160n-wpa-wireless-security

After you may have set the encryption type and key on the primary router, disconnect from this router. Now connect to the WRT54GS DD-WRT modded router, then go to the setup tab and alter the native community to 10.0.1.zero or no matter community vary you prefer.

* Local Ip Address: 10.0.1.1
* Subnet Mask: 255.255.255.0
* Gateway: 10.0.1.1
* Local Dns: 10.0.1.1

After you may have modified the community setup on your modded DD-WRT router, disconnect from the router then reconnect to so that you simply obtain your new ip address. Your new ip deal with should be someplace throughout the 10.0.1.0 network. Now open an online browser at point it in direction of 10.0.1.1, which is now the default gateway for your WRT54GS DD-WRT modded router.

Now go to the status tab and click on on the wireless tab. Throughout the wireless tab it's best to see a button that says site survey. The location survey button is located in the direction of the bottom of the page. All it's important to do now's choose router 1 from the listing, which should be the Linksys WRT160N.

After you have selected router 1 from the checklist, go to the wi-fi tab and click on on the wireless safety tab. All it's a must to do now's input the very same encryption sort and key that you just setup for router 1. After you've set the encryption sort and key into ybur modded DD-WRT router, all you must do is apply the settings. It's best to now have a wi-fi link between the Linksys WRT160N and the Linksys WRT54GS. Now connect utilizing a wi-fi connection to the DD-WRT modded router, and ensure your web connection work.
access point vs router