Open ports on D-Link router(DI Series) Tutorial - Computers - Hardware

For the DI-514, DI-524, DI-604, DI-614+, DI-624, DI-704P (revC), DI-704UP, DI-754, DI-764, DI-774, and DI-784:

Step 1: Open your web browser and enter the IP address of your D-Link router (192.168.0.1). Enter username (admin) and your password (blank by default).

Step 2: Click on the Advanced tab at the top and then click Virtual Server on the left side.

Step 3: Check Enabled to activate entry.

Step 4: Enter a name for your virtual server entry.

Step 5: Next to Private IP, enter the IP address of the computer on your local network that you want to allow the incoming service to.

Step 6: Choose Protocol Type - either TCP, UDP, or both. If you are not sure, select both.

Step 7: Enter the port information next to Private Port and Public Port. The private and public ports are usually the same. The public port is the port seen from the WAN side, and the private port is the port being used by the application on the computer within your local network.

Step 8: Enter the Schedule information.

Step 9: Click Apply and then click Continue.

For DI-704P (rev.B), DI-707P, DI-714P+, DI-804HV, DI-808HV, and DI-824VUP users:

Step 1: Open a web browser and enter the IP address of your router (192.168.0.1). Enter admin for your username and then your password (blank by default).

Step 2: Click on the Advanced tab and then Virtual Server on the left side.

Step 3: Enter the following information:

* Check the box next to Enable.* Next to Service Ports, enter the port or range of ports you want to open.* Next to Service IP, enter the IP address of the computer you want to open the port to.* Click Always next to Schedule or enter the time frame that you want.

Step 4: Click Apply and then click Restart to save your changes.

For DI-704, DI-704P (rev. A), DI-707, DI-711, DI-713, and DI-713P users:

Step 1: Open your web browser and enter the IP address of the router (192.168.0.1). Enter user name (admin) and your password (blank by default). If there is only 1 box, enter admin.

Step 2: Click on Advanced at the bottom and then click Virtual Server.

Step 3: Create a new entry:

* Enter the port or range of ports you want to open in the box under Service Ports.* Enter the IP address of the computer you want to open the ports to.* Check the box under Enable.

Step 4: Click Save and then click Reboot.

access point vs router